While I had performed two test cut (you can see the triangles on the right) it hadn’t picked up that there were still some issues. This is some Cricut vinyl I was silly enough to walk away from for a few minutes while it was cutting out. I have added a complete section below dedicated to settings for your design.Īs you can see above…. How you set your blade differs between the CM models and the DX models. It needs to do a “Kiss Cut” which is when the blade only cuts through the actual vinyl and not the backing paper or in the case of HTV the transfer sheet. The depth of your blade is especially important when cutting vinyl.
There is more information on this further along in the tutorial. In this project, I used Metamarc vinyl and came across some issues I hadn’t noticed with the vinyl when I had used it previously. Materials not attached to the mat well enough and slipĬutting issues with your Scan N Cut and vinylĮvery brand of vinyl is a little different.This may be the cardstock or vinyl that you have purchased. Reasons for your cut not to be as it should include: Some of these are simple troubleshooting types issues and then there are those that will not be fixed easily. Unfortunately, there are a lot of variables with crafting which in turn means there are a lot of causes why your project may not be cutting as well as you had hoped.
#Make the cut 4.1.0 not cutting full
This post may contain some affiliate links for your convenience (which means if you make a purchase after clicking a link I may earn a small commission but it won’t cost you a penny more)! Read my very boring full disclosure policy. A course by Jennifer Maker ~ SVG’s Made Simple.5 Tools That You Need For Your Scan N Cut.PRIVACY POLICY AND DISCLOSURE STATEMENT.Scan N Cut tutorials and more… Menu Toggle.